This article describes How to deploy and onboard Versa SDWAN Controller.

Please refer to the reference deployment architecture here

Prerequisite : Director,Analytics should be deployed.

Create a new Virtual Machines and load them with Versa-SDWAN Flex-VNF Software

Once VM is created, configure the Management IP on ETH0 interface

The  default Console login and password for Versa Flexvnf is

Username: admin

Password : versa123

Step 1 : Go to   Director > Workflows > Controller > Click on Add Button

Step 2 : Enter the Controller Name ,Select the Provider Organization

Check the Staging and Post staging.

172.16.1.3 :It is the eth1 IP address of Controller

Select the Analytics-cluster

Step 3 : Enter the Location details and click on Get Coordinates button.

Step 4 : We need to give network name ,

Select the  Interface vni-0/0, which connects to the Versa Director

172.16.1.100/24 :It is Northbound IP address of the Controller .

Step 5 :Click on +Wan Interface>Click On +Transport Domain

Create Transport Domain and Wan Interface

Select the Same Wan Interface  in Network Name

Interface vni-0/1 :It connects to MPLS

103.231.208.33/24:It is the Southbound IP address of the Controller (Controller WAN interface towards the MPLS)

103.231.208.34: It is the Gateway IP.

Step 6 : And then click on Deploy

Click on the Task button on the top right side on the Screen and see the progress.

Once it is deployed,the status will be as below.

Once the Controller is deployed, the Tunnel interfaces will be added

Here 

tvi-0/2.0 is VxLAN Tunnel Interface (Clear Text Tunnel)

tvi-0/3.0 is IPSec IKE Tunnel Interface

tvi-0/603.0 Analytics Virtual Router to route Analytics data between Analytics and Branches

vni-0/0.0 - Control Network Interface

vni-0/1.0 - Physical Interface for Underlay Network